- #Nabi sync download how to
- #Nabi sync download full
- #Nabi sync download android
- #Nabi sync download password
You only get one shot at this, so be gentle and careful.
So looking at the connector, go exactly 180 degrees and that is the one. The pins are unique for each position, so you have to pull the RIGHT pin out of the connector (the one that matches it). Now, you have to extract the right non-usb pin. With any luck, the non-usb pins will stay in the black plastic, and the usb pins will stay on the cable side. So I had to pull it out, and replace it with a pin from the other side of the connector.įirst, pull the plastic part of the connector off.
#Nabi sync download full
The picture above is after I put a good pin in, so yours may not quite match the picture, but it should be close.įrom Keith's picture, his cable had a full length extra pin, mine didn't. The un-used pin on my cable was actually cut short, yours may not be. Once you get the metal shield off, you'll need to scrape away the plastic from the un-used pin (it's next to the ground pin / black wire).
You'll need a sharp knife as that plastic is very tough. Be careful, while the pins aren't too small, it is easy to cut a wire once you have the shield off. You'll have to pry off the metal shield as well. Scrape the plastic and insulation from around the Nabi connector until it looks like the picture. Also, get yourself a USB OTG adapter from amazon and cut the micro usb end off. Get yourself a Nabi usb cable and cut it in half. That was my theory, and it is now proven. So the un-used pin he found, was the USB OTG select pin. And I discovered that the order of the pins is the exact same as a micro usb connector. Keith discovered that one side of the nabi connector has all the usb wires. Thanks Keith!įYI, a USB OTG device knows when a usb otg cable is plugged in because the 5th pin in the micro usb connector is connected to ground (sometimes via a resistor).
#Nabi sync download how to
Keith Green (aka: kgreen30) did a very cool write-up here of how to wirelessly charge a nabi tablet, and his pictures and pinouts of the cable led me to believe the USB OTG cable was possible. I did some research, and had a theory about the connector. Unfortunatly, Nabi (now owned by Mattel) doesn't put micro usb connectors on their tablets, and are out of stock of the USB OTG adapter cables on their website. It's nothing special, just a usb cable that has a micro usb connector on one end, and a female usb connector on the other.
#Nabi sync download android
With recovery it just goes to another screen with the android logo opened up being worked on, then it just loads normally.and STILL pops up with the download message and STILL won't accept my password.USB OTG is what lets you plug usb devices into smart phones and tablets.
#Nabi sync download password
When I try to reset the password from the tablet it also will not let me, just keeps saying it can't find my info.Īs of now the tablet is useless and were leaving for a 15 hour road trip tonight! This is very VERY not cool! I can't get on to see if it's actually logging into Wifi, can't get on to free space, and I've reset it numerous times and it STILL keeps telling me it's trying to download something.įurthermore, when I do the volume up and power buttons to factory rest, it only gives me three options.
I've tried both the nabi password that I can log into the website just fine with.and I've tried the google password associated with the email with the account. When I try to login, it keeps telling me I have the wrong password, it is NOT. If I close that prompt then it goes back to the not enough space message, it's a never ending cycle that won't go away! If I close out that message it prompts me to log into Dad mode. This is still an issue, right now I keep getting the "not enough space to download item, ask Dad to clear space".
0 kommentar(er)
